copper pour to board outline
Nigel Bishop , 05-28-2020, 06:10 AM
Hi can anyone help, I have just copied the board outline to a polygon pour, assigned a net and re-poured, the copper is going right up to the board edge, how do you pull it back please
df8 , 05-28-2020, 08:18 AM
Put Keep-Out Layer on top of the Board Outline. Adjust line thickness depending on desired clearance.
Nigel Bishop , 05-28-2020, 12:53 PM
Hi I have found a much better way, create a new rule in design rules>board Outline Clearance, Type a figure in minimum clearance, and the copper will pull back from board edge by this amount
Use our interactive Discord forum to reply or ask new questions.