About vias on differential pairs
mulfycrowh , 12-07-2021, 12:37 PM
Hi,
Changing the layer when routing a differential pair implies very close vias.
They trigger a clearance violation, here 0.07 mm on the attached screenshot.
Is it possible to get rid of this violation without changing the rule ?
Thanks
Changing the layer when routing a differential pair implies very close vias.
They trigger a clearance violation, here 0.07 mm on the attached screenshot.
Is it possible to get rid of this violation without changing the rule ?
Thanks
qdrives , 12-07-2021, 03:10 PM
It seems to me that it is the "solder mask sliver" rule.
Up to now, I have always ignored this rule and had the PCB fabricator handle it.
For via's you can also set a negative solder mask expansion.
Up to now, I have always ignored this rule and had the PCB fabricator handle it.
For via's you can also set a negative solder mask expansion.
robertferanec , 12-11-2021, 02:03 AM
@qdrives is right. PS: I almost always use masked (tented) VIAs.
Use our interactive Discord forum to reply or ask new questions.