The distance of copper in Flex slices
alferdvidal , 02-01-2018, 02:39 PM
Hi guys
I made a LED strip and sent it to the factory for production, but it said that the Copper distance is 0.05 and cannot produce it, I should leave a distance of 0.15. My question is, what should I do? Can anyone help me?
To further understand the question, the attached document may help
Thank you in advance
I made a LED strip and sent it to the factory for production, but it said that the Copper distance is 0.05 and cannot produce it, I should leave a distance of 0.15. My question is, what should I do? Can anyone help me?
To further understand the question, the attached document may help
Thank you in advance
robertferanec , 02-02-2018, 10:17 AM
You may need to correct clearance rule. Go to Design -> Rules -> Design Rules -> Electrical -> Clearance and check what is your smallest clearance. It should not be less than 0.15mm
alferdvidal , 02-02-2018, 11:51 AM
Hi Robert
Thanks a lot
Alrerd
Thanks a lot
Alrerd
Use our interactive Discord forum to reply or ask new questions.