Power and Ground Plane
mmogbel , 09-14-2022, 06:04 AM
Hello
I am not facing any problem with adding a plane layer into my PCB through Layer Stack Manager. But my problem is when I trying to assign a plane layer to a Net.
every one explain it like it is only to double click on the plane layer on PCB editor, but I do it a lot and nothing appear.
does there any different way to assign a plane layer to a Net ?
Thank you
I am not facing any problem with adding a plane layer into my PCB through Layer Stack Manager. But my problem is when I trying to assign a plane layer to a Net.
every one explain it like it is only to double click on the plane layer on PCB editor, but I do it a lot and nothing appear.
does there any different way to assign a plane layer to a Net ?
Thank you
qdrives , 09-14-2022, 02:47 PM
Make sure that the selection filter has "other" enabled (properties panel)
mmogbel , 09-15-2022, 12:30 AM
Thank you for your reply.
I am using 22.4.2 version, and I select "Other" on filtring but also i have the same problem.
I am using 22.4.2 version, and I select "Other" on filtring but also i have the same problem.
qdrives , 09-15-2022, 12:50 PM
Now, if you double click on the board region, you should get the question to connect the plane to a net.
Oh, and make sure that the plane layer is active, possible use the single layer mode just to make sure.
If it still does not work then I am out of ideas. I do not work with planes myself, so I have very little experience with it.
Oh, and make sure that the plane layer is active, possible use the single layer mode just to make sure.
If it still does not work then I am out of ideas. I do not work with planes myself, so I have very little experience with it.
robertferanec , 09-17-2022, 01:23 AM
This post may help you: https://designhelp.fedevel.com/forum...o-power-planes
Use our interactive Discord forum to reply or ask new questions.