Error in Altium Schematic
Mustafa kamal , 09-29-2024, 03:01 AM
Hello Sir Robert Feranec,Sir I am following your video on YouTube ' how to make custom ESP32 Board' to learn altium and it is very good, but sir as a follow your schematic after annotating I am still getting the red lines on the components and pins also alot of warnings, please help me with it. Thank you for the video it is amazing.
QDrives , 09-29-2024, 01:35 PM
The problem is not annotation.Some errors, other than the designator, also give a red line.Looking at your error list:- Only one pin: usually you made a typing error on a netlabel- Duplicate pins: Multiple pin 1 in component but they are not connected together- Floating netlabel: Netlabel is not on a line- Footprint not found: Have you created the footprint too? Named correct? Picked from a list?For some of the errors, I can imaging it is caused by the grid being to small. Make sure that the grid is set to 100mil when working in the schematic.
Use our interactive Discord forum to reply or ask new questions.