This website uses cookies
We use cookies or simmilar technologies to ensure you get the best experience on our website. By continuing to browse this website you consent to the use of such technologies. For more information visit our Privacy Policy.
| FORUM

FEDEVEL
Platform forum

USE DISCOUNT CODE
EXPERT30
TO SAVE $30 USD

Forum / Schematic Design & PCB Layout / Ground in 2 layer boards

Ground in 2 layer boards

danT , 01-16-2021, 08:50 AM
On 2 layer boards, I have seen many engineers define ground planes on the entire top and bottom layers. Then they proceed to place and route the components. They put a lot of vias to connect top and bottom ground planes. Is that a good practice? They used Eagle.
qdrives , 01-16-2021, 04:47 PM
Yes, and do not leave islands.
robertferanec , 01-18-2021, 05:11 AM
Normally I try to keep bottom as solid as possible and only use very short tracks there. If you like, have a look at our 28pins open source project layout:
Use our interactive Discord forum to reply or ask new questions.
Discord invite
Discord forum link (after invitation)

Didn't find what you were looking for?

CONTACT US