USE DISCOUNT CODEEXPERT30TO SAVE $30 USD
Slide switch rresistor placement
Alaeddine , 02-14-2025, 11:45 AM
Hi, i had my board designed and when i tested it with a multimeter i had different resistance values showing over these resistors when i pull the switch high. I guess i made a design mistake. are this resistor's placement correct like this or not ? Thanks in advance
QDrives , 02-14-2025, 08:45 PM
As in you measure the 12k resistor in parallel with everything that has a 'resistance' between +3.3V and Gnd? Of course.
QDrives , 02-14-2025, 09:31 PM
What do you measure?
Alaeddine , 02-15-2025, 08:08 AM
When i put the switch in Position 1 (+3V3) and check the continuity the resistor shorts so i measure 0 Ohm but when i switch to position 3(GND) i measure 0.3k then 0.5k then 1k.
QDrives , 02-15-2025, 12:56 PM
That is expected.What is the 'resistance' of a capacitor?
Alaeddine , 02-16-2025, 10:54 AM
Open connection ?
Use our interactive
Discord forum to reply or ask new questions.